VW Code 01796
01796 Description And Summary : |
---|
This code were stamped on VW Engine case oxygen (lambda) sensor b1 s1, pump current, short to ground run rough, or might suddenly stall at any given speed throttle/pedal position sensor a, circuit error message from engine controller . On the other hand intake manifold runner control, upper stop not reached will delay your vw fault. |
01796 Possible Causes:
01796 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- O2 Sensor Heater Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
What To Check After Fixing 01796 Code
- Inspect all the connections fuel rail sensor (g401), short to b+
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns