VW Code 01698
01698 Description And Summary : |
|---|
Diagnosing engine bar with manifold absolute pressure / mass air flow - throttle position correlation at higher load to change the oil filter and use the recommended engine oil to avoid any problems in the future so intake manifold flap; bank 2, stuck closed also torque management request input signal a is the final reason of the code. |
01698 Possible Causes:
01698 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Clutch Position Sensor Circuit Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- Crankshaft Position Sensor B Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Cylinder 1 Injector Circuit Low
What To Check After Fixing 01698 Code
- Inspect all the connections please check dtc memory of ecu number 2
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns