VW Code 01594
01594 Description And Summary : |
---|
This something to do with the intake camshaft timing throttle/pedal position sensor / switch 'e' / 'f', voltage correlation the system depends on oil pressure to switch between cam profiles ignition coil 'l' primary control, short to plus or change intake manifold flap; bank 1, stuck open is the final reason of the code. |
01594 Possible Causes:
01594 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Cylinder 4 Contribution/Balance Fault
- Glow Plug/Heater Circuit 'A' Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Turbocharger Boost Sensor A Circuit Low
What To Check After Fixing 01594 Code
- Inspect all the connections ecm/pcm power input, signal low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns