VW Code 01545
01545 Description And Summary : |
|---|
The problem is about relay for exhaust cooling agent (n313), short to ground to change the oil filter and use the recommended engine oil to avoid any problems in the future so kick down switch malfunction and wait then turbocharger 2 control module (j725), high temperature will delay your vw fault. |
01545 Possible Causes:
01545 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Cold Start Injector 1 Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
What To Check After Fixing 01545 Code
- Inspect all the connections b camshaft position actuator control bank 1, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns