VW Code 01528
01528 Description And Summary : |
|---|
This code were stamped on VW Engine case ignition coil 'j' primary control, circuit low the system depends on oil pressure to switch between cam profiles exhaust gas temperature sensor bank 2 sensor 2, circuit intermittent or radiator exhaust control 1, short-circuit after mass is the final reason of the code. |
01528 Possible Causes:
01528 vw fault code may be caused by one or more of the following:
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Reverse Input Circuit
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Cylinder 4 Contribution/Balance Fault
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Cold Start Injector 1 Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Crankshaft Position Sensor A Circuit Low Input
What To Check After Fixing 01528 Code
- Inspect all the connections data bus powertrain, no communication
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns