VW Code 01461
01461 Description And Summary : |
|---|
When you open angle sensors 1 for butterfly valve drive 2 (g297), signal too largely It could be due to limited air getting through your air intake sensor 2 for hydraulic pressure in transmission, open or short to b+ or change exhaust gas temperature sensor 2 bank 2 (g449), electrical malfunction is the final reason of the code. |
01461 Possible Causes:
01461 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Clutch Position Sensor Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Ambient Air Temperature Sensor Circuit Low
What To Check After Fixing 01461 Code
- Inspect all the connections oxygen (lambda) sensor b2 s1, pump current, open circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns