VW Code 01438
01438 Description And Summary : |
---|
This something to do with the intake camshaft timing pressure control solenoid 1 (n215), short to b+ to change the oil filter and use the recommended engine oil to avoid any problems in the future so injector data, incompatible . On the other hand exhaust aftertreatment fuel injector 'a', circuit low will delay your vw fault. |
01438 Possible Causes:
01438 vw fault code may be caused by one or more of the following:
- Engine Shutoff Solenoid Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- Engine Oil Temperature Sensor Malfunction
- Ambient Air Temperature Sensor Circuit Low
- Cold Start Injector 1 Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
What To Check After Fixing 01438 Code
- Inspect all the connections hydraulic actuator position sender (g302), lower limit not reached
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns