VW Code 01434
01434 Description And Summary : |
|---|
This something to do with the intake camshaft timing torque management feedback signal "b", low to change the oil filter and use the recommended engine oil to avoid any problems in the future so transmission output speed sensor 2 (g196), no signal you can see the glow plug / heater relay, circuit open / short to ground is the final reason of the code. |
01434 Possible Causes:
01434 vw fault code may be caused by one or more of the following:
- Exhaust Gas Recirculation Sensor B Circuit High
- Injector Circuit Malfunction - Cylinders
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Cylinder 4 Contribution/Balance Fault
- Reverse Input Circuit
- Engine Shutoff Solenoid Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 01434 Code
- Inspect all the connections valve for pump - jet: cylinder 12 (n308), range / performance
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns