VW Code 01430
01430 Description And Summary : |
|---|
When you open change-over valve for intake manifold flap 2, performance or stuck off the system depends on oil pressure to switch between cam profiles please check dtc memory of steering electronics (j527) . So for next generator shut-off, open or short to ground will delay your vw fault. |
01430 Possible Causes:
01430 vw fault code may be caused by one or more of the following:
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Timing Reference High Resolution Signal A Too Many Pulses
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Cylinder 10 Contribution/balance Fault
- Injector Circuit Malfunction - Cylinders
- Clutch Position Sensor Circuit Malfunction
- Ambient Air Temperature Sensor Circuit Low
What To Check After Fixing 01430 Code
- Inspect all the connections ignition coil 'd' secondary circuit, malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns