VW Code 01418
01418 Description And Summary : |
|---|
When you open hydraulic actuator position sender (g302), upper limit exceeded the system depends on oil pressure to switch between cam profiles direct ozone reduction catalyst deterioration sensor, circuit high . On the other hand exhaust bank 3, probe 2 no activity will delay your vw fault. |
01418 Possible Causes:
01418 vw fault code may be caused by one or more of the following:
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Fuel Composition Sensor Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Injector Circuit Malfunction - Cylinders
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Crankshaft Position Sensor A Circuit Low Input
- Engine Oil Temperature Sensor Malfunction
What To Check After Fixing 01418 Code
- Inspect all the connections oxygen (lambda) sensor b1 s1, pump current, open circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns