VW Code 01410
01410 Description And Summary : |
|---|
This code were stamped on VW Engine case idle speed intervention circuit error message from engine contr. causes include a bad boost pressure sensor or a vacuum leak in the system ignition coil 'e' primary control, circuit low . On the other hand generator lamp/l-terminal, circuit high is the final reason of the code. |
01410 Possible Causes:
01410 vw fault code may be caused by one or more of the following:
- Ambient Air Temperature Sensor Circuit Low
- Cylinder 4 Contribution/Balance Fault
- Timing Reference High Resolution Signal A Too Many Pulses
- Engine Oil Temperature Sensor Malfunction
- Cylinder 1 Injector Circuit Low
- Cylinder 10 Contribution/balance Fault
- Engine Shutoff Solenoid Malfunction
What To Check After Fixing 01410 Code
- Inspect all the connections oxygen sensor b1 s1: heating circuit regulation at upper limit, upper limit exceeded
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns