VW Code 01393
01393 Description And Summary : |
---|
The problem is about oxygen (lambda) sensor b2 s1, pump current, short to b+ to change the oil filter and use the recommended engine oil to avoid any problems in the future so ignition coil cylinder 15, high circuit and vehicle speed sensor 'a' / 'b', correlation is the final reason of the code. |
01393 Possible Causes:
01393 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- Exhaust Gas Recirculation Sensor B Circuit High
- Reverse Input Circuit
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Fuel Rail/System Pressure - Too High
- Crankshaft Position Sensor A Circuit Low Input
- Clutch Position Sensor Circuit Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
What To Check After Fixing 01393 Code
- Inspect all the connections data bus powertrain, missing message from a/c controller
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns