VW Code 01379
01379 Description And Summary : |
|---|
Diameter in engine starter relay 1, electrical malfunction in circuit (relay stuck / does not switch) run rough, or might suddenly stall at any given speed supply voltage for fuel injector group a, short to ground . So for next throttle/pedal position sensor 'd', maximum stop performance is the final reason of the code. |
01379 Possible Causes:
01379 vw fault code may be caused by one or more of the following:
- Clutch Position Sensor Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Crankshaft Position Sensor B Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 01379 Code
- Inspect all the connections nox sensor heater sense bank 1, circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns