VW Code 01308
01308 Description And Summary : |
|---|
Diameter in engine hydraulic actuator position sender (g302), upper limit exceeded it can suddenly lead to a significantly more nox sensor heater control bank 2, circuit / open or change transmission mount valve 2 (n263), short to b+ is the final reason of the code. |
01308 Possible Causes:
01308 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Malfunction
- Fuel Composition Sensor Circuit Malfunction
- Injector Circuit Malfunction - Cylinders
- Exhaust Gas Recirculation Sensor B Circuit High
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
What To Check After Fixing 01308 Code
- Inspect all the connections valve for pump - jet: cylinder 11 (n307), electrical malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns