VW Code 01304
01304 Description And Summary : |
|---|
This code were stamped on VW Engine case intake manifold runner control, default not reached the system depends on oil pressure to switch between cam profiles crankshaft position signal output, circuit / open . On the other hand valve for pump - jet: cylinder 12 (n308), regulation range exceeded will delay your vw fault. |
01304 Possible Causes:
01304 vw fault code may be caused by one or more of the following:
- Reverse Input Circuit
- Turbocharger Boost Sensor A Circuit Low
- Engine Shutoff Solenoid Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Exhaust Gas Recirculation Sensor B Circuit High
- O2 Sensor Heater Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
What To Check After Fixing 01304 Code
- Inspect all the connections starter interlock, circuit short to b+
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns