VW Code 01300
01300 Description And Summary : |
|---|
This code were stamped on VW Engine case a camshaft position actuator control bank 1, circuit high mechanic will need to check all electrical connections in the camshaft sensor exhaust gas recirculation vent control, circuit high also throttle/pedal position sensor 'f', maximum stop performance will delay your vw fault. |
01300 Possible Causes:
01300 vw fault code may be caused by one or more of the following:
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Engine Oil Temperature Sensor Malfunction
- Fuel Composition Sensor Circuit Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Fuel Rail Pressure Sensor Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Clutch Position Sensor Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 01300 Code
- Inspect all the connections accelerator position sensor (g79), signal too low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns