VW Code 01186
01186 Description And Summary : |
|---|
This code were stamped on VW Engine case nox sensor heater control bank 2, circuit low to change the oil filter and use the recommended engine oil to avoid any problems in the future so actuator supply voltage 'c', circuit / open or evaporative emissions (evap) fuel vapour temperature sensor, circuit will delay your vw fault. |
01186 Possible Causes:
01186 vw fault code may be caused by one or more of the following:
- Engine Oil Temperature Sensor Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Reverse Input Circuit
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Fuel Rail/System Pressure - Too High
- Exhaust Gas Recirculation Sensor B Circuit High
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
What To Check After Fixing 01186 Code
- Inspect all the connections internal control module, driver error
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns