VW Code 01182
01182 Description And Summary : |
|---|
This something to do with the intake camshaft timing exhaust bank 3 main catalyst, effectiveness too low the system depends on oil pressure to switch between cam profiles load signal stuck off you can see the valve for pump - jet: cylinder 12 (n308), regulation range exceeded will delay your vw fault. |
01182 Possible Causes:
01182 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Engine Oil Temperature Sensor Malfunction
- Ambient Air Temperature Sensor Circuit Low
- O2 Sensor Heater Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
What To Check After Fixing 01182 Code
- Inspect all the connections bank 1, cam shaft position sensor, discharge opening (g300), short-circuit to mass
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns