VW Code 01145
01145 Description And Summary : |
|---|
When you open oxygen (lambda) sensor b2 s1, pump current, short to ground retarded timing position, the engine might refuse to start ignition coil 'a' primary control, circuit low and wait then o2 sensor signal bank 1 sensor 1, biased / stuck rich will delay your vw fault. |
01145 Possible Causes:
01145 vw fault code may be caused by one or more of the following:
- Glow Plug/Heater Circuit 'A' Malfunction
- Cylinder 10 Contribution/balance Fault
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Crankshaft Position Sensor A Circuit Low Input
- Fuel Temperature Sensor B Circuit Range/Performance
- Injector Circuit Malfunction - Cylinders
What To Check After Fixing 01145 Code
- Inspect all the connections clutch pressure, adaptation at limit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns