VW Code 01128
01128 Description And Summary : |
|---|
This something to do with the intake camshaft timing pressure control solenoid 6 (n371) open / short to ground causes include a bad boost pressure sensor or a vacuum leak in the system intake manifold runner position sensor / switch, circuit high bank 2 . So for next exhaust pressure sensor will delay your vw fault. |
01128 Possible Causes:
01128 vw fault code may be caused by one or more of the following:
- Injector Circuit Malfunction - Cylinders
- Crankshaft Position Sensor B Circuit Malfunction
- Cylinder 1 Injector Circuit Low
- Engine Shutoff Solenoid Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Cylinder 10 Contribution/balance Fault
- Shift Solenoid E Performance or Stuck Off
What To Check After Fixing 01128 Code
- Inspect all the connections angle sensors 1 for butterfly valve drive 2 (g297), signal too largely
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns