VW Code 01110
01110 Description And Summary : |
|---|
This code were stamped on VW Engine case injection pump, fuel calibration not learned causes include a bad boost pressure sensor or a vacuum leak in the system reset-resistant limp-mode active and wait then turbocharger control module 2, implausible message will delay your vw fault. |
01110 Possible Causes:
01110 vw fault code may be caused by one or more of the following:
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Clutch Position Sensor Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- O2 Sensor Heater Circuit Malfunction
What To Check After Fixing 01110 Code
- Inspect all the connections mass-airflow sensor 4 (g457), signal to high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns