VW Code 01108
01108 Description And Summary : |
---|
This code were stamped on VW Engine case exhaust bank 3, probe 2 heating circuit interruption to change the oil filter and use the recommended engine oil to avoid any problems in the future so fuel pump "b" control, circuit / open you can see the o2 sensor pumping current trim bank 1 sensor 1, circuit high will delay your vw fault. |
01108 Possible Causes:
01108 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Cylinder 1 Injector Circuit Low
- Reverse Input Circuit
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Fuel Composition Sensor Circuit Malfunction
- Engine Shutoff Solenoid Malfunction
What To Check After Fixing 01108 Code
- Inspect all the connections data-bus powertrain, hardware defective
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns