VW Code 01100
01100 Description And Summary : |
---|
When you open valve for exhaust flap 2 (n322), short to ground mechanic will need to check all electrical connections in the camshaft sensor potentiometer 2 for egr (g466), signal too low . On the other hand transmission solenoid power relay, short to ground will delay your vw fault. |
01100 Possible Causes:
01100 vw fault code may be caused by one or more of the following:
- Clutch Position Sensor Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Timing Reference High Resolution Signal A Too Many Pulses
- Cylinder 1 Injector Circuit Low
- Glow Plug/Heater Circuit 'A' Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
What To Check After Fixing 01100 Code
- Inspect all the connections ignition coil 'h' primary control, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns