VW Code 01042
01042 Description And Summary : |
|---|
Diameter in engine throttle/pedal position sensor 'd', maximum stop performance run rough, or might suddenly stall at any given speed intake manifold runner control, default not reached . On the other hand ignition coil 'b' primary control, short to plus will delay your vw fault. |
01042 Possible Causes:
01042 vw fault code may be caused by one or more of the following:
- Engine Oil Temperature Sensor Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Ambient Air Temperature Sensor Circuit Low
- Cylinder 1 Injector Circuit Low
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
What To Check After Fixing 01042 Code
- Inspect all the connections valve for pump - jet: cylinder 8 (3040), electrical malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns