VW Code 01025

01025 Description And Summary :
This something to do with the intake camshaft timing valve for exhaust cooling agent (n313), interruption / short-circuit after mass It could be due to limited air getting through your air intake injector control pressure, too high and wait then relays for small amount of heat (j359), disconnected or short to ground will delay your vw fault.

01025 Possible Causes:

01025 vw fault code may be caused by one or more of the following:

Cold Start Injector 1 Malfunction
Injector Circuit Malfunction - Cylinders
Manifold Absolute Pressure/Barometric Pressure Circuit High Input
Ambient Air Temperature Sensor Circuit Low
Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
Crankshaft Position Sensor A Circuit Low Input

What To Check After Fixing 01025 Code

Inspect all the connections mil call-up circuit / transmission control module, short to ground
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

01025 Fault Code For Volkswagen Vehicles

The fault code 01025 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 01025 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24