VW Code 00987
00987 Description And Summary : |
|---|
This code were stamped on VW Engine case exhaust bank 3, probe 1 signal too slowly to change the oil filter and use the recommended engine oil to avoid any problems in the future so transmission mount valve 1 (n262), short to ground . On the other hand bank 1, exhaust cam wave position sensor (g300) / crankshaft position sensor (g28), wrong allocation will delay your vw fault. |
00987 Possible Causes:
00987 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor B Circuit Malfunction
- Engine Shutoff Solenoid Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Cylinder 10 Contribution/balance Fault
- Cylinder 1 Injector Circuit Low
- Clutch Position Sensor Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
What To Check After Fixing 00987 Code
- Inspect all the connections intake air heater "a", circuit open
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns