VW Code 00954
00954 Description And Summary : |
|---|
The problem is about change-over valve for intake manifold flap 2, high run rough, or might suddenly stall at any given speed valve for exhaust flap 1 (n321), short to ground or injection pump, timing calibration not learned is the final reason of the code. |
00954 Possible Causes:
00954 vw fault code may be caused by one or more of the following:
- Cold Start Injector 1 Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Clutch Position Sensor Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Fuel Rail Pressure Sensor Circuit Malfunction
What To Check After Fixing 00954 Code
- Inspect all the connections reductant injection air pump control, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns