VW Code 00911
00911 Description And Summary : |
---|
This code were stamped on VW Engine case exhaust bank 3 sensor 1 oxygen sensor signal, voltage too low during deceleration to change the oil filter and use the recommended engine oil to avoid any problems in the future so accelerator position sensor 2 (g185), signal too low or change accelerator position sensor 2 (g185), signal too high will delay your vw fault. |
00911 Possible Causes:
00911 vw fault code may be caused by one or more of the following:
- O2 Sensor Heater Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Cylinder 4 Contribution/Balance Fault
- Reverse Input Circuit
What To Check After Fixing 00911 Code
- Inspect all the connections exhaust gas temperature sensor, bank 2 sensor 5, circuit range / performance
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns