VW Code 00860
00860 Description And Summary : |
|---|
This code were stamped on VW Engine case accelerator pedal position sensor 2 (g185), signal too low It could be due to limited air getting through your air intake data-bus powertrain, implausible message from transmission controller you can see the o2 sensor signal bank 2 sensor 3, biased / stuck lean will delay your vw fault. |
00860 Possible Causes:
00860 vw fault code may be caused by one or more of the following:
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Cylinder 1 Injector Circuit Low
- Fuel Temperature Sensor B Circuit Range/Performance
- Engine Shutoff Solenoid Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
What To Check After Fixing 00860 Code
- Inspect all the connections transmission coolant circuit relay, short to b+
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns