VW Code 00840

00840 Description And Summary :
The problem is about torque management request input signal a to change the oil filter and use the recommended engine oil to avoid any problems in the future so intake manifold runner control, default not reached also injector cylinder 13 (n390), circuit high will delay your vw fault.

00840 Possible Causes:

00840 vw fault code may be caused by one or more of the following:

Injector Circuit Malfunction - Cylinders
Cylinder 4 Contribution/Balance Fault
Fuel Composition Sensor Circuit Malfunction
Engine Shutoff Solenoid Malfunction
Ambient Air Temperature Sensor Circuit Low
Cold Start Injector 1 Malfunction
Glow Plug/Heater Circuit 'A' Malfunction

What To Check After Fixing 00840 Code

Inspect all the connections accelerator position sensor (g79), signal too high
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

00840 Fault Code For Volkswagen Vehicles

The fault code 00840 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 00840 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24