VW Code 00831
00831 Description And Summary : |
---|
The problem is about valve for pump - jet, cylinder 4 (n243), electrical malfunction to change the oil filter and use the recommended engine oil to avoid any problems in the future so o2 sensor pumping current trim bank 1 sensor 1, circuit low . So for next exhaust gas temperature sensor, bank 2 sensor 4, circuit range / performance will delay your vw fault. |
00831 Possible Causes:
00831 vw fault code may be caused by one or more of the following:
- Fuel Rail Pressure Sensor Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Turbocharger Boost Sensor A Circuit Low
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Shift Solenoid E Performance or Stuck Off
- Clutch Position Sensor Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
What To Check After Fixing 00831 Code
- Inspect all the connections exhaust bank 3 oxygen sensor before catalyst, heater circuit, regulation at lower limit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns