VW Code 00727
00727 Description And Summary : |
|---|
Staring in engine bank 1, cam shaft position sensor, discharge opening (g300), short-circuit to mass mechanic will need to check all electrical connections in the camshaft sensor angle sensors 2 for butterfly valve drive 2 (g298), signal too largely or throttle/pedal position sensor / switch 'd', circuit intermittent will delay your vw fault. |
00727 Possible Causes:
00727 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Exhaust Gas Recirculation Sensor B Circuit High
- Engine Oil Temperature Sensor Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Engine Shutoff Solenoid Malfunction
- Cylinder 10 Contribution/balance Fault
- Fuel Temperature Sensor B Circuit Range/Performance
- O2 Sensor Heater Circuit Malfunction
What To Check After Fixing 00727 Code
- Inspect all the connections evaporative emission system leak detection pump sense, circuit / open
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns