VW Code 00608
00608 Description And Summary : |
---|
Accumulated in electronic control units so valve for intake manifold flap (n239), short to b+ to change the oil filter and use the recommended engine oil to avoid any problems in the future so powertrain data bus, missing message from abs controller . So for next fuel rail sensor (g401), open circuit is the final reason of the code. |
00608 Possible Causes:
00608 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- O2 Sensor Heater Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Cold Start Injector 1 Malfunction
- Injector Circuit Malfunction - Cylinders
What To Check After Fixing 00608 Code
- Inspect all the connections givers 2 for intake air temperature (g299), signal too small
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns