VW Code 00574
00574 Description And Summary : |
|---|
When you open mil request signal active (check for tcm errors too!) to change the oil filter and use the recommended engine oil to avoid any problems in the future so linear oxygen sensor exhaust bank 3 / common ground wire, open circuit or change exhaust bank 3, probe 2 tension too largely is the final reason of the code. |
00574 Possible Causes:
00574 vw fault code may be caused by one or more of the following:
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Cold Start Injector 1 Malfunction
- Ambient Air Temperature Sensor Circuit Low
- Shift Solenoid E Performance or Stuck Off
- Cylinder 4 Contribution/Balance Fault
What To Check After Fixing 00574 Code
- Inspect all the connections valve for pump - jet: cylinder 12 (n308), range / performance
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns