VW Code 00475
00475 Description And Summary : |
|---|
This code were stamped on VW Engine case butterfly valve drive 2 (g296) of electrical errors in the electric circuit to change the oil filter and use the recommended engine oil to avoid any problems in the future so ng high pressure valve (n372), short to ground and wait then injector control pressure, too low - engine cranking will delay your vw fault. |
00475 Possible Causes:
00475 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Crankshaft Position Sensor A Circuit Low Input
- Fuel Rail/System Pressure - Too High
- Turbocharger Boost Sensor A Circuit Low
- Cold Start Injector 1 Malfunction
- O2 Sensor Heater Circuit Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Fuel Composition Sensor Circuit Malfunction
What To Check After Fixing 00475 Code
- Inspect all the connections rough road / engine torque signal from abs; electrical malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns