VW Code 00428
00428 Description And Summary : |
---|
This code were stamped on VW Engine case o2 sensor out of range during deceleration bank 1 sensor 1 It could be due to limited air getting through your air intake o2 sensor signals swapped bank 1 sensor 2 / bank 1 sensor 3 you can see the turbo/super charger wastegate solenoid c (n388), signal high will delay your vw fault. |
00428 Possible Causes:
00428 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Crankshaft Position Sensor A Circuit Low Input
- Timing Reference High Resolution Signal A Too Many Pulses
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
What To Check After Fixing 00428 Code
- Inspect all the connections oxygen (lambda) sensor b2 s1, signal shorted to heater circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns