VW Code 00426
00426 Description And Summary : |
|---|
Staring in engine exhaust bank 3, probe 2 tension too largely retarded timing position, the engine might refuse to start linear oxygen sensor exhaust bank 2 / reference voltage, short to ground you can see the bank 2, cam shaft position sensor, discharge opening (g301), short-circuit to mass will delay your vw fault. |
00426 Possible Causes:
00426 vw fault code may be caused by one or more of the following:
- Clutch Position Sensor Circuit Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Engine Oil Temperature Sensor Malfunction
- Cold Start Injector 1 Malfunction
- O2 Sensor Heater Circuit Malfunction
- Shift Solenoid E Performance or Stuck Off
- Crankshaft Position Sensor A Circuit Low Input
What To Check After Fixing 00426 Code
- Inspect all the connections pressure control solenoid 5 (n233) short to b+
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns