VW Code 00371
00371 Description And Summary : |
|---|
Accumulated in electronic control units so hydraulic pressure sensor 2 adaptation at limit to change the oil filter and use the recommended engine oil to avoid any problems in the future so exhaust bank 3/4 lambda probes after kat exchanges you can see the intake manifold runner position sensor / switch, circuit bank 2 will delay your vw fault. |
00371 Possible Causes:
00371 vw fault code may be caused by one or more of the following:
- Timing Reference High Resolution Signal A Too Many Pulses
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Engine Shutoff Solenoid Malfunction
- Clutch Position Sensor Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Engine Oil Temperature Sensor Malfunction
What To Check After Fixing 00371 Code
- Inspect all the connections rough road / engine torque signal from abs; electrical malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns