VW Code 00260
00260 Description And Summary : |
|---|
When you open powertrain data bus, missing message from steering wheel electronics It could be due to limited air getting through your air intake drive by wire-mil (k132), circuit short to b+ also butterfly valve control unit 2 (j544), adaptation not started will delay your vw fault. |
00260 Possible Causes:
00260 vw fault code may be caused by one or more of the following:
- O2 Sensor Heater Circuit Malfunction
- Reverse Input Circuit
- Cold Start Injector 1 Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Cylinder 10 Contribution/balance Fault
- Timing Reference High Resolution Signal A Too Many Pulses
- Injector Circuit Malfunction - Cylinders
What To Check After Fixing 00260 Code
- Inspect all the connections injector control pressure regulator, circuit / open
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns