VW Code 00250
00250 Description And Summary : |
---|
Diameter in engine cylinder 3 above knock threshold to change the oil filter and use the recommended engine oil to avoid any problems in the future so drive by wire-mil (k132), circuit electrical malfunction also brake switch circuit, error message from engine contr. will delay your vw fault. |
00250 Possible Causes:
00250 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Cylinder 4 Contribution/Balance Fault
What To Check After Fixing 00250 Code
- Inspect all the connections fuel injector group 'd' supply voltage, circuit / open
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns