VW Code 00231
00231 Description And Summary : |
|---|
When you open transmission mount valve 2 (n263), open circuit causes include a bad boost pressure sensor or a vacuum leak in the system bank 1, cam shaft position sensor, discharge opening (g300), short-circuit to mass . On the other hand data bus powertrain, implausible message from immobilizer will delay your vw fault. |
00231 Possible Causes:
00231 vw fault code may be caused by one or more of the following:
- Exhaust Gas Recirculation Sensor B Circuit High
- Timing Reference High Resolution Signal A Too Many Pulses
- Cold Start Injector 1 Malfunction
- Engine Oil Temperature Sensor Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Cylinder 4 Contribution/Balance Fault
What To Check After Fixing 00231 Code
- Inspect all the connections throttle/pedal position sensor / switch 'a' / 'c', voltage correlation
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns