VW Code 00103
00103 Description And Summary : |
|---|
This code were stamped on VW Engine case throttle actuator control system, forced limited power causes include a bad boost pressure sensor or a vacuum leak in the system o2 sensor pumping current trim bank 2 sensor 1, circuit high or change cylinder 8 above knock threshold will delay your vw fault. |
00103 Possible Causes:
00103 vw fault code may be caused by one or more of the following:
- Clutch Position Sensor Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Fuel Rail Pressure Sensor Circuit Malfunction
- Shift Solenoid E Performance or Stuck Off
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Reverse Input Circuit
What To Check After Fixing 00103 Code
- Inspect all the connections exhaust bank 4, sensor 2 heater circuit, interruption
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns