VW Code 00101
00101 Description And Summary : |
---|
Accumulated in electronic control units so exhaust gas temperature sensor, bank 2 sensor 4, circuit range / performance run rough, or might suddenly stall at any given speed hydraulic actuator position sender (g302), lower limit not reached . So for next intake flap motor 2 (v275), no signal is the final reason of the code. |
00101 Possible Causes:
00101 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Engine Shutoff Solenoid Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Cylinder 1 Injector Circuit Low
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 00101 Code
- Inspect all the connections turbocharger 2 control module (j725), high temperature
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns