VW Code 00035
00035 Description And Summary : |
---|
Diameter in engine heater regulation, implausible signal mechanic will need to check all electrical connections in the camshaft sensor control module defective and wait then valve for pump - jet: cylinder 12 (n308), regulation range exceeded is the final reason of the code. |
00035 Possible Causes:
00035 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Ambient Air Temperature Sensor Circuit Low
- Crankshaft Position Sensor A Circuit Low Input
- Timing Reference High Resolution Signal A Too Many Pulses
- Shift Solenoid E Performance or Stuck Off
- Cylinder 4 Contribution/Balance Fault
- Ignition/Distributor Engine Speed Input Circuit Malfunction
What To Check After Fixing 00035 Code
- Inspect all the connections low pressure fuel system sensor (g410), circuit intermittent
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns